Figure 12(a) - Sides of Curb Ramps - Flared Sides (description below)

Figure 12(a)
Sides of Curb Ramps
Flared Sides

Note: If X is less than 48 inches, then the slope of the flared side shall not exceed 1:12.

This figure shows a typical curb ramp, cut into a walkway perpendicular to the curb face, with flared sides having a maximum slope of 1:10. The landing at the top, measured from the top of the ramp to the edge of the walkway or closest obstruction is denoted as "x". If x, the landing depth at the top of a curb ramp, is less than 48 inches, then the slope of the flared side shall not exceed 1:12.

 

 

Virginia Commonwealth University | www.dbtac.vcu.edu
National Institute on Disability and Rehabilitation Research (#H133A060087-01)
VCU DBTAC Coordination, Outreach and Research Center
1112 East Clay Street| P.O. Box 980330 | Richmond, Virginia 23298-0330
Phone: (804)827-0917 | Fax: (804) 828- 828-1321
This website is maintained by the VCU DBTAC Coordination, Outreach and Research Center.
The VCU DBTAC Coordination, Outreach and Research Center does not provide ADA technical assistance.
For ADA technical assistance, contact your local Center at 800-949-4232.
About this site.